|
|
#22
01-08-2020, 08:06 PM
|
||||
|
||||
You have a butt-load of perseverance, Gerry! Kudos to you!
 Hope the op goes a expected...
__________________
TA Arcmaster 185 w/tig/stick kit MillerMatic 252 w/3rd gen 30A MM140 w/o AS, w/CO2 Hobart (Miller) 625 plasma Hobart 250ci plasma Victor O/A (always ready, but bored) HF 80 lunchbox w/tig 45ACP Black Talons for those stubborn jobs... 
|
|
#23
01-08-2020, 08:59 PM
|
||||
|
||||
|
Thanks MCC.
Today I hovered near the phone waiting for the call to tell me what pre-op clinic to go to....nada. I'll rock their boat tomorrow. Instead of air arcing out the bad spot on the bucket, cause if I'm wearing ear plugs, I can't hear a ring, I did some lathe work. I did some threading on the lathe on a 2.17" hole at 14TPI. I don't do enough threading on the lathe to be cocky and casual, it's a white knuckle time for me. This is for a hydraulic puller. Terry Lingle gave me some Enerpac cylinders years back, and I have made a puller plate for it years ago. But it was a bit small then and it's arms are really small now for what I seem to be doing. This thread came out really nice and that was encouraging. Now it goes on the mill.
__________________
Gerry You got freedom of speech, if you don't say too much. Aaron Neville. When a liberal screams racism, you can bet they were also born with white skin. One of the things my dad taught me is that the world is your bathroom -- Quick Dick McDick
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
