|
|
#22
04-22-2019, 03:20 AM
|
||||
|
||||
Quote:
__________________
Keith Measure twice and cut once...or...wait, was that the other way around? 
|
|
#23
04-23-2019, 02:17 PM
|
||||
|
||||
|
Quote:
I retired, for a couple of years, then got an offer I couldn't refuse from a friend and went back to work part time, only that part time got closer to full time after a couple more years. Finally had to pull the pin again, this time permanently as I was getting to have too much pain and limited mobility from arthritis. Still wouldn't mind going to work for him again if I could run his backhoe, bobcat or mini excavator, but he likes doing that work himself.
__________________
Miller Thunderbolt XL AC/DC Hobart Handler 190 Angle grinders,14" chop saw,Hobart medium duty O/A set Some air tools,fair selection of hand tools,and other "stuff" ____________________________________________ The difference between genius and stupidity, is that genius has limits. Albert Einstein
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
