Shop Floor Talk  

Go Back   Shop Floor Talk > Welding and Metalworking Forums > Fabrication

SFT Search:   
Reply
 
Thread Tools Display Modes
  #41  
Old 08-23-2019, 10:23 PM
LKeithR's Avatar
LKeithR LKeithR is offline
Hey...wait...is there a prize?
 
Join Date: Aug 2011
Location: Langley, B.C.
Posts: 5,061
Default

Quote:
Originally Posted by milomilo View Post
Get 3 used hydraulic rams and build your self a slip roller.
Makin' cones on a slip roller probably isn't any easier than bump bending them. I've done it both ways and I can't say that either way has an advantage. With slip rolls you've got to leave extra material on each end for the run out so that has to be trimmed and fitted. I think the biggest thing is whichever way you're most familiar with.

From start to finish I wouldn't be ashamed if it took me 6 hrs. to make two of those. You're right that it probably should be less but when you're only doing stuff like that once in a while it always takes longer to figure it out...
__________________
Keith

Measure twice and cut once...or...wait, was that the other way around?
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Web Search:

All times are GMT -5. The time now is 07:45 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.