|
|
#2
10-24-2010, 05:52 PM
|
||||
|
||||
A complete and thorough review is expected
__________________
Mac ___________________________________________ One extremely happy  former convict of the penal colony that lies between NY, PA, and DE. Now living the good life much further south. where they don't know what fucking Carhartts are.
|
|
#3
10-24-2010, 09:09 PM
|
|||
|
|||
|
That is what I use. The Help section is well very helpful also there is a bunch of tutorials on youtube. still makes my head hurt at times. I would not begin to say I am proficient at using it but I am better than when I started by that I mean there is a huge learning curve but the tools are there to help climb it.
|
|
#5
11-02-2010, 10:02 PM
|
||||
|
||||
|
I brought this up the other day, I got the email and downloaded it. It is a pretty nice program, identical to my autocad 2006 that I have. Same commands. I like it quite a bit, and it didn't cost me anything unlike the autocad.
http://www.shopfloortalk.com/forums/...ght=draftsight was probably missed because I put it in off topic.
__________________
Tony “Use it up, wear it out, make it do, or do without”
|
 |
| Tags |
| cad |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
