|
|
#1
12-16-2021, 11:36 AM
|
||||
|
||||
Hobart foot pedal?
Stuck at work or I could do more research. T.I.A. Last edited by gimpyrobb; 12-18-2021 at 11:37 AM. 
|
|
#3
12-16-2021, 02:31 PM
|
||||
|
||||
|
Get TIG pedals at SSC controls. LINK The chart will list what else is compatible...
Sounds like a fair deal. You can always bring a stinger and see if it will stick weld.
__________________
TA Arcmaster 185 w/tig/stick kit MillerMatic 252 w/3rd gen 30A MM140 w/o AS, w/CO2 Hobart (Miller) 625 plasma Hobart 250ci plasma Victor O/A (always ready, but bored) HF 80 lunchbox w/tig 45ACP Black Talons for those stubborn jobs...
|
|
#4
12-16-2021, 02:31 PM
|
||||
|
||||
|
Before your give him some money, make sure its a single phase machine.
that is in less you have three phase. Also check the voltage required.
__________________
* * The factory of the future will have only two employees, a man and a dog. The man will be there to feed the dog. The dog will be there to keep the man from touching the equipment. ~Warren G. Bennis
|
|
#5
12-16-2021, 03:58 PM
|
||||
|
||||
|
__________________
Chris One of the penalties for refusing to participate in politics is that you end up being governed by your inferiors. Plato LET'S GO BRANDON!!!! B biggest I idot D democrats E ever N nominated
|
|
#7
12-16-2021, 09:01 PM
|
|||
|
|||
|
Did it come leads and torch, just not the foot pedal? Was it single phase? For 275 looks you got pretty good deal there.
|
|
#8
12-17-2021, 01:56 PM
|
||||
|
||||
|
Quote:
 I bet you could get the same price if you called and said "can you match the eebay price" because they will then save on fees (about 10+%).
__________________
TA Arcmaster 185 w/tig/stick kit MillerMatic 252 w/3rd gen 30A MM140 w/o AS, w/CO2 Hobart (Miller) 625 plasma Hobart 250ci plasma Victor O/A (always ready, but bored) HF 80 lunchbox w/tig 45ACP Black Talons for those stubborn jobs...
|
|
#9
12-18-2021, 10:48 AM
|
||||
|
||||
|
Yes it's single phase. Just the power supply, nothing else. Long story short, the guy told me that it had issues and I'm willing to gamble once in a while.
Said it was his father's who passed and when he hooked it up, it will strike an arc but not maintain an arc. He only tried with stick welding not tig, so I am going to source a cheap foot pedal and try that too. This is too busy of a season, it's sat on the trailer till today. I will be dragging it in the garage and testing it out shortly. Keep your fingers crossed for me.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
