|
|
#28
08-05-2022, 12:47 PM
|
||||
|
||||
I've watched the 2nd video of the failure over and over and from what I can see the self aligning bearings that failed were in the link between the eccentric and the top arm. Do I have that right?
The top bearing could be a heim joint since it doesn't rotate much. The bottom bearing does need to rotate with the eccentric, so maybe a better bearing? Or spacers/washers to keep them contained?
__________________
Bill in sunny Tucson I believe in gun control. Gun Control: The ability to consistently hit what you are aiming at. Weldor by choice, engineer by necessity. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode