|
|
#11
07-08-2022, 06:37 PM
|
||||
|
||||
__________________
Chris One of the penalties for refusing to participate in politics is that you end up being governed by your inferiors. Plato LET'S GO BRANDON!!!! B biggest I idot D democrats E ever N nominated 
|
|
#14
07-08-2022, 09:30 PM
|
||||
|
||||
|
Damn Doug, that looks like it is going to be one sweet rig.
__________________
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." Winston Churchill
|
|
#15
07-08-2022, 10:30 PM
|
||||
|
||||
|
Looking good.
Sent from my iPhone using Tapatalk
__________________
Brian You don't know what you don't know. "It's what you learn after you know it all that counts." John Wooden 
|
|
#16
08-04-2022, 10:26 AM
|
||||
|
||||
|
Blasted and painted the water tray.
Hope to have some help friday installing it, will then work on slat holders. Been running machine around a bit, changing settings, seeing what they doo. Manual are auto translated "Chinglesh" and pretty bad. So, by adding time (in seconds) to the various settings, I figured out what each one does. I think I have flame cutting set up they way I want it to work. That is, light torch, rapid into position, hold at the preheat height, wait until I push "start" again, which then starts the oxy, delay movement (presently .5 second), drops down to burn height, and then runs the contour. Last edited by digger doug; 08-04-2022 at 11:08 AM.
|
|
#17
08-04-2022, 09:03 PM
|
||||
|
||||
|
Looking real nice. What is the 1st project?
__________________
Chris One of the penalties for refusing to participate in politics is that you end up being governed by your inferiors. Plato LET'S GO BRANDON!!!! B biggest I idot D democrats E ever N nominated
|
|
#18
08-05-2022, 07:19 AM
|
||||
|
||||
|
I'm thinking the slat holders for the water table....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
