Shop Floor Talk  

Go Back   Shop Floor Talk > Welding and Metalworking Forums > Machining

SFT Search:   
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 12-13-2018, 06:02 PM
Lu47Dan's Avatar
Lu47Dan Lu47Dan is offline
Connoisseur of Old Iron
 
Join Date: Mar 2006
Location: N/W Pa.
Posts: 5,971
Default 4 jaw chucks, independent vs. scroll.. 8" or 10"

Thinking out loud it helps to clear the cobwebs.
I have for a long time wanted to purchase a 4 jaw chuck for the Clausing. But with the L00 mount used chucks were not plentiful around here or on the net. CDCO has one model, plain back, no mount, but they sell the mount also. It's main drawback is no rpm rating. So the search has drug on for a very longtime.
The other day I was searching for dividing head and stumbled on a 4 jaw chuck, 6",8",or 10" independent, with a semi-finished L00 mount . It has an rpm rating of 2100rpm. More than enough for me. Fitting the chuck to the mount is not that complicated, there have been several done here and there a more than a few series on Youtube showing the process. Most all my questions have been answered on that front.
The main question is what size to get?
I have a 8" 3 jaw on the lathe as the only workholding device right now.
Buying a 10" 4 jaw independent chuck id not too much more than the 8" 4 jaw independent is, but would the 10" be too big for my Clausing 6903 14" X 30" lathe?
The title of this thread says, independent vs. scroll....
I am going to buy one of each, the scroll has its uses, one of which is to drill into the end of square stock when dead nuts accuracy is not needed. I might have a production job of that nature, this coming spring. A 5C collet chuck will not work as the pieces are beyond the size range of the collets.
And the 4 jaw independent chuck will get a lot of use once I get started on the crawler again.
I am going to replace the 3 jaw also, but I would like to find a Set Tru or similar chuck to replace it with.
Any comments, ideas, or hard experience will help.
Dan.
__________________
Tools to Men are like Shoes to Women , you can never have too many !!
Used diesel engines are an adventure anyway you look at them !!
Miller XMT-304 Multiprocess
Miller 10-E Wire Feeder
Miller Spectrum 2050 Plasma Cutter
Hobart AC/DC stick welder
Hobart 175 Mig
Craftsman O/A set
Turbo torch and B-tank
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Web Search:

All times are GMT -5. The time now is 08:46 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.