Shop Floor Talk  

Go Back   Shop Floor Talk > Welding and Metalworking Forums > Machining

 
 
SFT Search:
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 06-12-2008, 02:35 PM
Cavalry's Avatar
Cavalry Cavalry is offline
Below Wholesale
 
Join Date: Jul 2005
Location: Evil Empire State
Posts: 9,041
Default Dont fear the Titanium

I have a few jobs to do that require titanium. I asked advice here as I had never worked with it before. I was expecting a tough job...I was in for a surprise.

I picked up some 6al-4v off ebay. I have a baby 10" lathe that is WWII vintage so I was a little worried about that. My insert selection is limited so I decided to just give the coated TCMT's I have a shot.
I plowed off into it with a fast feed as suggested. It cut beautiful with a good finish. I had some stringy chips that I am sure the correct insert would have taken care of. My coolant setup was a mess so I decided to give it a shot dry. That really was no problem at all! As long as I fed hard I could take pretty decent cuts for my machine without bogging at all.

So far it has been a very painless experience. If you can turn stainless then dont be afraid of titanium at all.
__________________
Director of Cryptography-Upstate NY Division
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Web Search:

All times are GMT -5. The time now is 04:57 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.