|
|
#1
12-18-2018, 08:24 AM
|
||||
|
||||
Made a thin bushing
Coworker asked me if I wanted a challenge yesterday. He need a thin seal install bushing made to install a $200 seal without cutting it on sharp edge of a hydraulic motor shaft. I turn out a piece of alum round for him. It was only about .030” thick in the big part tapering to nothing for the seal to start, and where it went over the shoulder, was only .010” thick. He and the boss was impressed. Probably will be making more of these in the future for different applications. When I parted it off, it created a slightly rolled edge that keeps it snug on the shaft, so it should work good.
Sent from my iPhone using ShopFloorTalk
__________________
Brian You don't know what you don't know.  "It's what you learn after you know it all that counts." John Wooden 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode