Shop Floor Talk  

Go Back   Shop Floor Talk > Welding and Metalworking Forums > Fabrication

SFT Search:
Thread Tools Display Modes
Old 05-11-2022, 05:42 PM
Chris P Chris P is offline
Join Date: Jan 2021
Location: Colorado
Posts: 4
Send a message via Yahoo to Chris P
Default Homestead Bender #2

I would like to do some edge bending with the Hossfeld Bender #2 that I purchased used. I have all the necessary components with the exception of the set of long and short spacer blocks. I tried scaling off a photo knowing that the edge die pins are 3/4" in diameter. The photo was taken at an angle, so I didn't have much success. Could anyone who has one of these benders provide a dimensioned drawing for one of the long and short spacers? That would allow me to fabricate a set of spacers.
Reply With Quote

#two, edge bend, hossfeld bender, spacers

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Web Search:

All times are GMT -5. The time now is 08:49 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.