#1
|
||||
|
||||
Stick welder shocking me on DCEP
While doing that car hauler axle install I used 7018 rod on DCEP as specified by the Miller calculator.
I got the crapped knocked out of me every time I touched the metal or held the ground clamp. Even through gloves and standing on my feet with rubber sole boots. I was wet with sweat and my gloves were also damp but I wasn't grounded was I? Anyway, I changed over to DCEN and it never shocked me again. I also noticed the rod ran better on DCEN than it did on DCEP What the heck was happening? I don't usually get shocked and as hot as it is here I am usually always wet with sweat.
__________________
http://www.welding-tv.com |
Thread Tools | |
Display Modes | |
|
|