View Single Post
  #10  
Old 04-10-2013, 06:54 PM
Walker's Avatar
Walker Walker is offline
Standard of Excellence
 
Join Date: Aug 2004
Location: Cave Creek AZ
Posts: 4,671
Default

Seems like an awful lot of work that could be better spent on your other projects. Why don't you either bend flat bar with two holes in the ends into a U with legs, another plate with matching holes and use bolts. Or, and an even better idea I think, is to bend plain hot rolled round bar 3/8" and weld studs cut from your all thread onto the sides. You would be done a heck of a lot quicker and it would be stronger to boot! If you saved time here you could even fire up your GoTorch and cut out the end plates.
__________________
Walker
Chief slag chipper and floor sweeper, Ironwood Artistic
Reply With Quote