View Single Post
  #2  
Old 08-31-2019, 06:18 PM
digger doug's Avatar
digger doug digger doug is offline
Not to be used as a Flotation Device
 
Join Date: Jan 2008
Location: NW Pa
Posts: 11,748
Default

Jenn,
I can't understand the diagram, but does that motor run a cam, that shoves
the one jaw towards the other, during welding ?

I thought DoAlls all ran a simple spring loaded jaw set-up.

If this motor runs the cam, it could be a Stryco welder.

It will spin until it gets satisfied, the jaw dropping into the spot on the cam, and hitting a limit switch.
Reply With Quote