View Single Post
  #2  
Old 01-15-2019, 09:56 PM
Scratch Scratch is offline
Senior Member
 
Join Date: Feb 2007
Location: Hudson WI
Posts: 490
Default

I also found that a 5/8" square, 14 gauge wall pipe, slides very tightly over the 1/2" round bar. It needs to be tapped on, but comes off by twisting back and forth.

There were two holes drilled in the angle iron already since this was cut from drops, but I did drill two more holes so I could hang them on the wall easily.

I'm excited to fire up the forge and try them out, but didn't have time today.
Attached Thumbnails
Click image for larger version

Name:	6.jpg
Views:	137
Size:	55.9 KB
ID:	148858   Click image for larger version

Name:	7.jpg
Views:	141
Size:	54.1 KB
ID:	148859   Click image for larger version

Name:	8.jpg
Views:	128
Size:	72.3 KB
ID:	148860  
Reply With Quote