View Single Post
  #9  
Old 03-18-2018, 02:08 PM
LKeithR's Avatar
LKeithR LKeithR is offline
Hey...wait...is there a prize?
 
Join Date: Aug 2011
Location: Langley, B.C.
Posts: 5,068
Default

Quote:
Originally Posted by RED caddy View Post
Well, we already know the correct bore size (1.128") and stroke does not seem to be a big deal in this case. I was just concerned that 2 "O" rings might not stand up to 24-2500 PSI and a better seal setup might need to be brought to bear...
Good point...hadn't thought of that. For 2500 psi you'll need to go to a proper cup type seal. If you do decide to mess around with a larger bore it's handy to remember that "doubling" the diameter of the bore gives you "exactly" 4 times the surface area...
__________________
Keith

Measure twice and cut once...or...wait, was that the other way around?
Reply With Quote