View Single Post
Old 12-04-2018, 11:43 PM
GWIZ's Avatar
GWIZ GWIZ is offline
SFT Historian
Join Date: Feb 2006
Location: USA
Posts: 7,070

Yes, single end, 3/8" shank, 0.200 tip is what I use all the time.

Double ended ones do not hold very well in drill chucks so I don't recommend them, (shanks are ground just a little smaller so the chuck clamps on the larger diameter of the tip) .
The factory of the future will have only two employees, a man and a dog. The man will be there to feed the dog. The dog will be there to keep the man from touching the equipment. ~Warren G. Bennis
Reply With Quote