View Single Post
Old 12-04-2018, 10:09 PM
Ironman's Avatar
Ironman Ironman is offline
Iron Modification Investigator
Join Date: Feb 2008
Location: Warburg, Alberta, Canada
Posts: 13,695

I got a set of those, but often use a thin piece of paper instead.
Something I find far more useful is a co-axial indicator
Pay no attention to ra-ra American made blah blah accuracy nonsense. These things are not for accuracy, they are for centering, and as they rotate you move the cross slides to find the spot where there is the least wiggle of the needle. You don't measure with them.
They are useful on a mill and held in a tailstock chuck are useful in a lathe as well.
You got freedom of speech, if you don't say too much.
Aaron Neville

"I must abide by my core values, my ethical responsibilities and constitutional obligations. There can be a cost to acting on one’s principles, but there is a bigger cost to abandoning them.” Jane Philpott
Reply With Quote