View Single Post
  #18  
Old 01-07-2019, 12:07 PM
MetalWolf's Avatar
MetalWolf MetalWolf is offline
Lubrication Consultant
 
Join Date: Jan 2011
Location: La Vernia,Tx.
Posts: 3,412
Default

Quote:
Originally Posted by Ironman View Post
FWIW, with a 10 ton ram, and probably all 2" o.d. rams.
The thread is 14 TPI.
As nobody invented a pipe thread, metric manufacturers have used National Pipe and made it a straight taper-less thread. That is what this cylinder uses, and a pipe coupling will work, but because of the taper it does not screw in more than 5/8 inch. I don't consider that enough on a taper.
I have threaded a hole in a 5"x12"x1" bar to screw the cylinder into, and slotted each side for pulling. Works well.
Hey Gerry, Ya lost me there am a bit slow today
__________________
MetalWolf, AKA---- Metallic Shapeshifter-----

I Have Only One Wish, To Achieve "Pura Vida" In All That I Do!
Reply With Quote