View Single Post
  #10  
Old 06-13-2022, 10:36 AM
digger doug's Avatar
digger doug digger doug is offline
Banned
 
Join Date: Jan 2008
Location: NW Pa
Posts: 14,033
Default

Quote:
Originally Posted by Oscar View Post

The slats on the bottom are laser-cut to ± 0.003", so when the top is clamped down to them, they help bring it down to their level. Obviously they will flex too, so that is where the judicious selection of clamping pressures comes into play as well.
The website made no distinction from the ribs to the "top" materials.

Hot rolled plate is not that accurate in thickness, so saying that the top will be held to the .003 tolerance of the laser cut notches is meaningless, unless you are using the underside.

Is your continued touting of these because you have a financial interest ?
Reply With Quote