View Single Post
  #6  
Old 07-29-2006, 02:14 AM
houlibar's Avatar
houlibar houlibar is offline
Lord of the Reins
 
Join Date: Jul 2005
Location: SoCal, most advanced third world country
Posts: 1,893
Default

Quote:
Originally Posted by cutter
Well Scott, in the first place with 240 volts AC you don't have postive or negative; you have 2 hots, 1 neutral and a ground on the 4 pin plug. The 2 hots should be the 2 outside pins. You need to know a little more information but I think your plasma cutter would need the 2 hots and neutral. Check your schematics to be sure.
Gotcha. 120V x 2 = 240V. So the consensus is leave off the neutral and wire the half-round which is the ground on the 4 prong to the round on the 3 prong which is also ground. Yes?
__________________
Scott
Reply With Quote