View Single Post
  #14  
Old 12-05-2018, 02:16 PM
JH35's Avatar
JH35 JH35 is offline
Elite Member
 
Join Date: May 2011
Location: South Central Lower Michigan
Posts: 1,091
Default

Quote:
Originally Posted by GWIZ View Post
Yes, single end, 3/8" shank, 0.200 tip is what I use all the time.

https://www.shopfloortalk.com/forums...40&postcount=4

Double ended ones do not hold very well in drill chucks so I don't recommend them, (shanks are ground just a little smaller so the chuck clamps on the larger diameter of the tip) .
Same here. Sometimes a piece of paper, sometimes just touch off on the part depending on what is needed. Indicator to line up on a hole or round part.

1200 RPM or so BTW. they explode at 5000 plus I know.

Jeff

edit. May not have been 5000. may have been 10,000. its been a long time and I do not recommend it.
__________________
Curator of the canned cycles.

I'm a man, but I can change, if I have to, I guess.--Red Green

Home is where the G91G28X0Y0 is.
Reply With Quote