View Single Post
  #29  
Old 12-14-2013, 09:06 AM
johnyradio johnyradio is offline
Member
 
Join Date: Dec 2013
Location: San Francisco
Posts: 55
Default

Quote:
Originally Posted by Scrapper Greg View Post
Ok, what I was talking about was to take the nuts (circled in red) off and slide off the metal shield (green arrow), then put the main part on the inside of the lid with the terminal area out through the hole you cut and replace the shield on the outside of the lid. Sandwiching the lid between the plastic and the metal shield. That would also secure it without any extra hardware.
ah yes, thx for suggestion. i considered that. But i believe that would cause the sockets to be recessed (due to the thickness of the sheet metal), and so the male pins would not insert fully into the sockets.
Reply With Quote