View Single Post
  #7  
Old 05-17-2019, 12:10 AM
LKeithR's Avatar
LKeithR LKeithR is offline
Hey...wait...is there a prize?
 
Join Date: Aug 2011
Location: Langley, B.C.
Posts: 5,084
Default

If the customer had the time and was willing to pay for it I'd replace the bottom with a heavier piece but it all depends on the customer. Some don't want to be without the bucket and some don't want to spend the money--been there lots of times before. If you're going to rebuild it I'd consider some kind of wrap on the inside to tie the two pieces together. A piece of 3/16 flat or 10 GA sheet with a bit of a bend in it would tie it together nicely...
__________________
Keith

Measure twice and cut once...or...wait, was that the other way around?
Reply With Quote