View Single Post
  #16  
Old 07-09-2016, 09:29 PM
cutter's Avatar
cutter cutter is offline

12-29-1943 to 1-17-2020
Curmudgeon emeritus
 
Join Date: Jun 2004
Location: Lubbock,Texas
Posts: 33,110
Default

I was perplexed by the challenge of figuring out how to mount the sleeve to the head and have it be aligned correctly. I decided it should be adjustable, at least temporarily.

For reasons of his own, Old Man had sent me a box full of 2.25" x 7 gauge drops from from someone's iron worker.
I decided to see if I could finally find a use for a few of them, four of them as it turned out.

1 - 4. More accurately, 2 pairs. One disc of each pair is drilled and tapped while the other is slotted way beyond what I actually needed but I figured that overkill was a good option. The center holes are for a pivot pin or bolt.

The goal is to provide a setup that can pivot in two planes, horizontal & vertical.

Here are some steps along the way.
Attached Thumbnails
Click image for larger version

Name:	slotted1.jpg
Views:	364
Size:	64.5 KB
ID:	133547   Click image for larger version

Name:	slotted2.jpg
Views:	369
Size:	64.4 KB
ID:	133548   Click image for larger version

Name:	slotted3.jpg
Views:	360
Size:	64.9 KB
ID:	133549   Click image for larger version

Name:	slotted4.jpg
Views:	358
Size:	64.5 KB
ID:	133550  
__________________
cutter
Housekeeping Staff: the Gatekeeper
Director of Policy, Syntax and Grammar (by appointment)

"Dr. Chandran, will I dream?"

Just Keep Walking

"I am not a body, I am free.
For I am still as God created me."
Reply With Quote