Thread: Bump bending
View Single Post
  #12  
Old 08-16-2019, 04:13 AM
toprecycler's Avatar
toprecycler toprecycler is offline
Elite Member
 
Join Date: Jan 2009
Location: Petoskey, Michigan
Posts: 3,959
Default

Quote:
Originally Posted by LKeithR View Post
You might find that you have to make the cones in two pieces. The top of the bender where the punch is held will have a certain thickness. If you make the cones from one piece of material you'll find that as they start closing up they will run into the upper section and start pinching it. Getting the right amount of bend in a situation like this can be a bit tricky...


My thoughts to, especially with 1/8” material. Going to be a little stiff. 1/16” would be a little more flexible.[emoji4]


Sent from my iPhone using ShopFloorTalk
__________________
Brian

You don't know what you don't know.

"It's what you learn after you know it all that counts." John Wooden
Reply With Quote