View Single Post
Old 06-01-2018, 07:18 PM
TriHonu's Avatar
TriHonu TriHonu is offline
Senior Member
Join Date: May 2007
Location: St Paul, Minnesota, USA
Posts: 434

There were a few companies that made a High Frequency box that you attached to your stinger and ground cables.

I have one like the one below that I used in my desire to learn to TIG weld.

Some discussion on it Shop Floor - Scratch TIG

I never could get good results with my arc welder. I ended up buying an older transformer TIG welder and the learning curve was much more manageable.
There is nothing quite as permanent as a good temporary repair.
People are not the solution, because Most People are the problem...
Reply With Quote