View Single Post
  #25  
Old 05-17-2009, 03:36 PM
kbs2244 kbs2244 is offline
Elite Member
 
Join Date: Sep 2006
Location: Way North Illinois
Posts: 1,638
Default epoxy

I have never done a whole system with copper and epoxy.
Just quick and dirty add ons where the flame may have been a little less than a good idea.
I preped it like always.
Good and clean inside and outside.
I just used the side by side epoxy stuff that you squeeze out on a piece of paper and mix.
Put a good coat on the outside of the male piece, push it in, give it a 1/4 turn back and forth and wait 24 hours.
I think maybe twice in water systems and maybe 4 times in air.
The air systems never got above 140 PSI
Reply With Quote