View Single Post
  #19  
Old 04-01-2019, 10:22 AM
greywynd's Avatar
greywynd greywynd is offline
I can dig it
 
Join Date: Dec 2005
Location: Wainwright, Alberta
Posts: 4,741
Default

The mill is a ‘new to me’ deal, and nice to have for sure. The lathe I’ve had an ran for a few years at the farm I had, needs some wiring done to get it going again. I really need to find a magnetic starter for it, and change it over to that. Haven’t had a lot of luck finding a decent one for a reasonable price. In time I may swap it from single to 3phase and use a vfd instead, or I may end up building a roto phase yet, will wait and see.

Still have about an hours work to get the shaper up and running. Will likely take an hour to clear the stuff around it to get started. Some of this stuff will just happen as/when I need it likely.


Sent from my iPhone using ShopFloorTalk mobile app
Reply With Quote