View Single Post
  #19  
Old 11-13-2012, 10:51 AM
Windy_Acres's Avatar
Windy_Acres Windy_Acres is offline
Chairman of the Headboard
 
Join Date: Jun 2012
Location: Where ever I hang my hat...
Posts: 5,764
Default

Quote:
Originally Posted by Lu47Dan View Post
Windy, a long shaft pencil grinder with a stone or a burr works too.
Cut into the bushing with the appropriate cutter for the material,a longitudinal groove just down to the OD of the bushing, then you can break the bushing out of the bore.
I have done this many times when I could not get a bushing to move out of the bore.
It can be slow work, but it does have its advantages.
Dan.
Gotcha, Ive got a set of carbide bits that I run in a straight die grinder, that and a cape chisel would work too..

thanks for the tip, Windy
__________________
Whiskey bottles, and brand new cars, Oak tree you're in my way....
Reply With Quote