View Single Post
Old 11-13-2012, 09:12 AM
Windy_Acres's Avatar
Windy_Acres Windy_Acres is offline
Chairman of the Headboard
Join Date: Jun 2012
Location: Northwest Illinois,.. the land of Fat Greasy Pancakes
Posts: 5,835

Originally Posted by BurningMetal View Post
If you can get it in a press you can get a washer with the same outside diameter as your bushings grind a flat spot on each side and slide it through and turn it sideways into your slot. I don't know if you have enough room to do that or not. I have done this many times for bearings and bushings. It is a lot stronger than you think it would be.
In this case, I wont be getting it into the press, but I do a significant amount of press work on other items, never tried the washer as you have described it, but I will give it a try in the future, sounds like a good idea, thanks for the tip !
Reply With Quote