View Single Post
Old 05-17-2019, 07:14 PM
MetalWolf's Avatar
MetalWolf MetalWolf is offline
Lubrication Consultant
Join Date: Jan 2011
Location: La Vernia,Tx.
Posts: 3,577

Originally Posted by Walker View Post
What king of tool, and what tool did you make it out of? Ifeally you would want to know the type of steel.
I used one of those cheap automotive door panel tools you pop door panels off with see pic below.

I needed to bend it to a hook and then intended to harden it so it would act as a pry bar in a way...

because it fits perfectly around the valve guide to pry up and off the guide seals that are stubbornly stuck to the guides.

I was going to try to use the one in the top part of the pic but that seal puller is just too large to get into the spot needed. so, I used the door panel tool under in bottom of the pic.

Click image for larger version

Name:	DSCF1878.jpg
Views:	69
Size:	196.6 KB
ID:	150812
Reply With Quote