View Single Post
  #1  
Old 03-16-2021, 02:39 PM
tigman250's Avatar
tigman250 tigman250 is offline
The Right Stuff
 
Join Date: Aug 2006
Location: Michigan
Posts: 1,806
Send a message via AIM to tigman250 Send a message via MSN to tigman250
Default Okamoto surface grinder help

Good afternoon all, I have a surface grinder that is giving me fits, the table is hydraulically driven and occasionally slows down when moving to the left. It seems to work flawlessly for about an hour in the morning, after that starts acting up so whatever it is seems to be thermally triggered. The manual calls for the pressure to be set at 210 PSI, when it is acting up the pressure drops to 150 psi, if I set the pressure to 175 PSI it goes the same speed both directions just slower than if set higher but doesn't "kick out". So far I have cleaned every single valve and solenoid, changed the pressure relief valve and just put on a new pump. The new relief valve and pump have helped a little bit, before changing them I could only run 125PSI to keep it from kicking out. Seems like a valve is hanging up half way and dumping the pressure but I have swapped the table directional valve with another one from the cross feed, I have swapped solenoid coils around, like stated earlier cleaned all the valves and replaced relief valve and vane pump. Any hydraulic experts out there that can help a brother out? I am almost embarrassed that I can't figure this thing out, it's been kicking my butt for a month now, just replaced the pump yesterday and thought I had it but after a half a day of running it today the operator came and told me it's acting up again.....

Thanks All!
__________________
The one that dies with the most tools wins

If it's worth having, it's worth working for

I carry a gun because I'm too young to die and too old to take an ass whoopin!
Reply With Quote