View Single Post
  #1  
Old 05-13-2019, 09:59 AM
RonRock RonRock is offline
Junior Member
 
Join Date: Dec 2011
Location: Iowa
Posts: 12
Default Suggest a Knurling Tool for me?

I am in need of a Knurling tool for use on my Logan 11" lathe. It has a AXA toolpost. I have the two roller that typically comes with the AXA toolpost setups. I want to replace it with a scissors type that puts pressure on top and bottom rather than push against the piece and chuck.

So of course I have searched a bit and like usual found several from several different vendors. Anybody have any suggestions of one that they have used or purchased and like? Is any of them better than the others?
Reply With Quote