View Single Post
Old 09-07-2012, 08:43 PM
platypus20's Avatar
platypus20 platypus20 is offline
Boiler God
Join Date: Aug 2007
Location: camillus, ny (syracuse)
Posts: 9,833

Originally Posted by Vern2 View Post
What is needed for a Hypertherm 45 to Plasma Cam connections.

1) Opening the plasma cutter case, then splicing two wires to a remote relay, to control torch on/off leads.

2) Second connection would be the torch okay signals.

3) The last connection would have to do with measuring the torch voltage, when buying the THC, must have option. It may consist of a transformer and torch voltage wires going through the transformer a few times.

You can see this can be intense. Please, don't say it's easy and it's on the install CD, been told that already.

I don't need blow by blow. You can say, "All three of the connections have to me done". Will that's intense.


Why would you alter the wiring inside the machine, when there is a machine interface built into the machine, available through the factory installed Amphenol plug on the back of the machine ?? See pages 4-28 and 4-29 of the Powermax 45 owners's manual.
Reply With Quote