View Single Post
Old 01-05-2019, 07:12 AM
MetalWolf's Avatar
MetalWolf MetalWolf is offline
Lubrication Consultant
Join Date: Jan 2011
Location: La Vernia,Tx.
Posts: 3,526

Originally Posted by LKeithR View Post
If you don't need to tram the table of your mill very often or you have lots of time then you can certainly get away with a dial indicator. I did it for many years but I finally broke down about a year ago and bought myself one of the "Edge" spindle squares and I'm very happy with it. Makes tramming the table much easier and quicker. There are a lot of tools and gadgets out there that are just "gimmicks" but a spindle square is not one of them. I wouldn't be without it now...


In your opinion Using fore mentioned materials and directions Is this DIY spindle square worth while. ??

And if made properly should be fairly accurate. ??
MetalWolf, AKA---- Metallic Shapeshifter-----

I Have Only One Wish, To Achieve "Pura Vida" In All That I Do!
Reply With Quote