View Single Post
Old 01-05-2019, 12:16 AM
milomilo's Avatar
milomilo milomilo is offline
Auction Addict
Join Date: May 2010
Location: Wheatland, Wyoming
Posts: 16,176

Originally Posted by MetalWolf View Post
Well if I make one and it comes out rite, I have enough aluminum stock material to make two.... I'll make one for you too... you will need to get the two Dial indicators from HF I bought one, On one day and used the 20% off and bought another one the day after and used another 20% off so it came out less than 20 bucks... but they look fairly simple to make...

I do need to go get a couple of 3/16th. bull nose end mills still.... but thought id start on one tomorrow so I'll let yawl know how it comes out....
I already have the two indicators. I had planned on using steel since I have no aluminum. A little heavier but what I have on hand. Also considering a cylinder square build. Nice of you to offer. Let me know if there is anything you need I might have.

The question isn't who is going to let me; it's who is going to stop me.
Reply With Quote