Thread: New Stand
View Single Post
  #26  
Old 12-01-2018, 09:51 PM
Farmersamm Farmersamm is offline
Senior Member
 
Join Date: Mar 2009
Location: Oklahoma
Posts: 711
Default

Once the new mounts are welded in place, the pads are bolted to the mounts, and the pads are then ready to be tacked to the pedestal.

The lift at the back of the cabinets, to accommodate the sloping floor, is about 5/16".

Pads are tacked, and ready for finish welding. Same same wedging while finish welding. Very simple way to accommodate just about any required angle/slope. No need for fancy wedges, or adjustable feet. Can be tweaked with shims if necessary.

Once this is complete, the floor plate will be attached to the pedestals, and drilled to accept wood screws for anchoring to the floor.
Attached Thumbnails
Click image for larger version

Name:	stand15.JPG
Views:	81
Size:	133.2 KB
ID:	148337   Click image for larger version

Name:	stand13.JPG
Views:	85
Size:	131.6 KB
ID:	148338   Click image for larger version

Name:	stand14.JPG
Views:	81
Size:	138.2 KB
ID:	148339  
__________________
Any day above ground is a good day

http://www.farmersamm.com/
Reply With Quote