Thread: Hallelujah
View Single Post
  #1  
Old 11-28-2018, 06:50 PM
milomilo's Avatar
milomilo milomilo is offline
Auction Addict
 
Join Date: May 2010
Location: Wheatland, Wyoming
Posts: 14,917
Default Hallelujah

Finally got me a mill. It is a Grizzly G1006. Has a 2hp motor. Goes for 50-2100 RPM. Came with set (12) of R8 collets, about 15 end mills, hold down set and a 6" vise and a decent home made steel table. Cost me $500 for the package. It was all a filthy mess. Looks like the owner never cleaned it while he owned it. Don't think he used it all that much as 5 of the collets were still in the original wrappers.

Has a few small divots in the table but nothing large. Vise was in the same shape. Had a lot of surface rust which came off easily with emery and a random orbit sander. Found out after cleaning it it is a Browne & Sharp vise. Nice surprise. The table gib adjustment screw is missing so now to search and see if I can find one. One table lock down screw is missing.

Bubba went with me to Cheyenne to help get it loaded. Estimating is weighs around 5-6 hundred lbs. We plugged it in with the belts off and the motor runs smooth as glass. One belt needs replaced. The top end is at Bubba's place till it gets all cleaned up.

Pics are before cleaning, except for the table. More pics tomorrow after cleaning and some assembly. It is all manual drive, no DRO (yet).
Attached Thumbnails
Click image for larger version

Name:	SAM_2324.jpg
Views:	130
Size:	181.5 KB
ID:	148284   Click image for larger version

Name:	SAM_2320.jpg
Views:	127
Size:	203.9 KB
ID:	148285   Click image for larger version

Name:	SAM_2321.jpg
Views:	137
Size:	205.2 KB
ID:	148286   Click image for larger version

Name:	SAM_2322.jpg
Views:	134
Size:	204.1 KB
ID:	148287  
__________________
Chris

Politics is the art of looking for trouble, finding it everywhere, diagnosing it incorrectly and applying the wrong remedies.
Groucho Marx

Last edited by milomilo; 11-28-2018 at 06:56 PM.
Reply With Quote