View Single Post
  #6  
Old 03-24-2010, 04:50 PM
troutback troutback is offline
Junior Member
 
Join Date: Feb 2009
Location: new york
Posts: 19
Default

that would be great platypus. i'll pay for copies and shipping.

so, if anyone else is reading this, i ran into another problem today. i was giving it a test run by milling some aircraft aluminum and somehow snapped the set screw that holds the r-8 shaft in place. came out when i was taking the shaft out. didn't seem to do anything that caused it, but what the heck do i know?

i was trying to figure out how to get at the area where the set screw lives. it is covered by the bearing. don't know where to start....take the bearing out? take the shaft out? not sure what's attached where.....now would be a good time to have that manual.
Reply With Quote