View Single Post
  #3  
Old 07-21-2019, 11:26 PM
greywynd's Avatar
greywynd greywynd is offline
I can dig it
 
Join Date: Dec 2005
Location: Wainwright, Alberta
Posts: 4,840
Default

Easiest is to mill one out of brass or aluminum, and drill/tap it for a couple small button head screws. I think I have a couple to make sometime, will have to take a look, it’s down on the ‘to-do’ list yet.

A wire brush on a bench grinder will knock a lot of that rust off, then either scotch brite, emery or stones after that to finish cleaning things up. And then some light oil, fluid film etc is nice for storage.


Sent from my iPhone using ShopFloorTalk mobile app
Reply With Quote