View Single Post
Old 11-12-2018, 04:37 PM
GWIZ's Avatar
GWIZ GWIZ is offline
SFT Historian
Join Date: Feb 2006
Location: USA
Posts: 6,882

Was it this one?

Originally Posted by precisionworks View Post
Messer MG600 is the only rod I've ever used that consistently removes bolts, studs, taps, etc. Even if they're broken way down in the hole, MG600 will get them out.

That angle can't be as bad as welding out broken exhaust manifold bolts from underneath the car/truck I don't do that often, and normally charge double for removal - that covers the burns & supplies used. But it really isn't that hard, no more difficult than any other overhead SMAW weld.
The factory of the future will have only two employees, a man and a dog. The man will be there to feed the dog. The dog will be there to keep the man from touching the equipment. ~Warren G. Bennis
Reply With Quote