Thread: Bump bending
View Single Post
  #33  
Old 08-23-2019, 06:53 PM
Ironman's Avatar
Ironman Ironman is offline
Iron Modification Investigator
 
Join Date: Feb 2008
Location: Warburg, Alberta, Canada
Posts: 13,790
Default

This is for Cutter, the rest of you don't look
Pictures of the cones in various stages of assembly.

I started with the knife top die and was not having any fun because the bottom die was too short. I switched to a round piece of stock that I made attachment to the top die, and used the long wide bottom die. When that worked, I hunted down a ragged flame cut bit of 1/2" and clamped it to the mill table and ripped it straight and welded it to the rod.

It took way too long and I'll charge about 1/2 the time I spent, chalk the rest down to learning.
Attached Thumbnails
Click image for larger version

Name:	DSC03976.jpg
Views:	70
Size:	196.9 KB
ID:	151914   Click image for larger version

Name:	DSC03977.jpg
Views:	72
Size:	188.7 KB
ID:	151915   Click image for larger version

Name:	DSC03979.jpg
Views:	70
Size:	177.2 KB
ID:	151916   Click image for larger version

Name:	DSC03982.jpg
Views:	68
Size:	190.1 KB
ID:	151917   Click image for larger version

Name:	DSC03984.jpg
Views:	71
Size:	188.3 KB
ID:	151918  

__________________
Gerry
You got freedom of speech, if you don't say too much.
Aaron Neville.

The virtue is always a cover for the sin. That's the key to understanding the modern left. Whatever they're accusing you of doing, they are doing themselves but more enthusiastically. And that's definitely the story of Justin Trudeau. Tucker Carlson
Reply With Quote