Thread: Forming Steel
View Single Post
  #9  
Old 10-27-2018, 02:39 PM
Steeveedee Steeveedee is offline
Member
 
Join Date: Nov 2012
Location: California
Posts: 86
Default

Thanks! I'll make a couple of blocks with the inside radius of the rod on their edges to form the rods over. I have both 3/16" and 1/4" rods to bend.

I'm not too worried about them being brittle. These are hand tools only; they will not see any strikes from a mallet. If people want to buy them, they will be warned about not using a mallet. Some people in my wood carving class have expressed an interest, but I'm not in any hurry to set up a production run- I'm retired!
Reply With Quote