View Single Post
  #7  
Old 12-05-2013, 08:28 PM
camdigger's Avatar
camdigger camdigger is offline
Roving Reporter
 
Join Date: Aug 2008
Location: Central Oilberta
Posts: 3,653
Default

At low speeds, the behaviour may just be to roll on the shaft IF the tension is just right.

Even so, with such large clearance, the behaviour of the pulley wheel will be unpredictable. Hopping, flopping side to side, etc may happen depending on the dynamic load fluctuations.

Better to just put in a 1x2 bushing imho....
__________________
Design to 0.001", measure to 1/32", cut with an axe, grind to fit..
Reply With Quote