Shop Floor Talk  

Go Back   Shop Floor Talk > Search Forums

SFT Search:   
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: DENedbalek
Forum: Machining 05-14-2019, 08:03 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Yes, I'm pretty confident. I ran into this...

Yes, I'm pretty confident. I ran into this thread & pitch before on my Enco drill press handles. Seemed odd but I worked around it. The rods were fine, but the ball handles were crapped out. I...
Forum: Machining 05-14-2019, 08:00 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Yeah, that was one of the sites I found. They...

Yeah, that was one of the sites I found. They don't have the nuts. Thanks though.
Forum: Machining 05-14-2019, 07:59 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Thanks Cutter. I searched the usual spots, but...

Thanks Cutter. I searched the usual spots, but didn't find these. And they both had both the right & left nuts.
Forum: Machining 05-14-2019, 07:36 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Ah, ok. I have some some 3/4" hex stock on hand...

Ah, ok. I have some some 3/4" hex stock on hand so I wasn't thinking along those lines. Thanks for the feedback though.
Forum: Machining 05-14-2019, 07:05 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
I understand the making of thread cutting bits...

I understand the making of thread cutting bits out of HSS, but I don't understand the 7/16 Heavy Nuts application.
Forum: Machining 05-14-2019, 07:04 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Black & Decker Cat. No. 9403 Type 1.

Black & Decker Cat. No. 9403 Type 1.
Forum: Machining 05-14-2019, 05:03 PM
Replies: 15
Views: 1,566
Posted By DENedbalek
Threading challenge

Folks, I am new to the forum, well not new, but seldom if ever have posted anything. But now I'm stuck and need your advice. I have a bench grinder that came to me in a deal, but it had shaft...
Forum: Fabrication 03-04-2012, 08:14 AM
Replies: 12
Views: 5,436
Posted By DENedbalek
Shelly, You need to show us the wiring...

Shelly,

You need to show us the wiring diagram for the switch. The motor wiring is pretty straight forward, so the piece you're missing is the wiring of the switch between the line voltage coming...
Showing results 1 to 8 of 8

 
Forum Jump
Web Search:

All times are GMT -5. The time now is 04:03 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.