Shop Floor Talk  

Go Back   Shop Floor Talk > Search Forums

SFT Search:   
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Search: Posts Made By: 25twin
Forum: Fabrication 02-09-2014, 08:04 PM
Replies: 29
Views: 6,267
Posted By 25twin
digr, As long as you remember to lubricate the...

digr,
As long as you remember to lubricate the top rollers every two or three years it rolls very well. If you move it in real close to the pipe it can be a little tough to move back out.
Forum: Fabrication 02-09-2014, 07:16 PM
Replies: 29
Views: 6,267
Posted By 25twin
I've tried to attach photos of my crane. We'll...

I've tried to attach photos of my crane. We'll see.
I like it because it covers both doors and the open center area of my shop. As long as you can get something in either of the overhead doors you...
Forum: Fabrication 02-08-2014, 11:08 PM
Replies: 29
Views: 6,267
Posted By 25twin
Mr. Cutter, I'm one of the most non-computer...

Mr. Cutter,
I'm one of the most non-computer guys you can imagine. If it can be screwed up I can do it. I'll take some photos tomorrow and give it a shot.
Forum: Fabrication 02-08-2014, 07:41 PM
Replies: 29
Views: 6,267
Posted By 25twin
Oledog, Basically mine is set same up as the...

Oledog,
Basically mine is set same up as the one pictured. It is a jib with a gantry type a-frame support. The a-frame is attached to the main beam with a roller assembly and can moved in or out as...
Forum: Fabrication 02-07-2014, 10:35 AM
Replies: 29
Views: 6,267
Posted By 25twin
There may be some issues with the construction of...

There may be some issues with the construction of the crane pictured. Here it is, however, I have a very similar one in my shop. It is based on an 8 inch steel pipe that was set 3 ft. deep in a...
Showing results 1 to 5 of 5

 
Forum Jump
Web Search:

All times are GMT -5. The time now is 05:45 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.