Shop Floor Talk  

Go Back   Shop Floor Talk > Members List

SFT Search:

Greenbuggy Greenbuggy is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. mkwambold
    03-22-2011 05:49 AM
    hello again greenbuggy i just wanted to update the gyro-flo 125 situation i found that the blow down valve is not working properly it pops off a bit late so i have had to look for a new valve with no luck however i did install a simple ball valve in the same air stream and open and close it on shut off / start up and this seams to work ok till i can find a proper blow down valve any ideas were to look thanks for your help mike
  2. mkwambold
    01-13-2011 02:54 PM
    hello green can you please send me an email i just got on this site and i seen you have a gyro-flo 125 i do too and i need some info on the air/oil lines if you could help me out it would be great please email me at i really need this help please thanks mike w.

About Me

  • About Greenbuggy
    Boone, IA
    Computers, old trucks, electronics, vintage video games
    Student/Forklift Op
  • Signature
    Don't try this at home - UNLESS you live in a HOSPITAL!


Total Posts
Visitor Messages
General Information
  • Last Activity: 05-25-2012 10:04 PM
  • Join Date: 08-24-2005
  • Referrals: 1

Contact Info

Instant Messaging
Send an Instant Message to Greenbuggy Using...
Home Page
This Page
Web Search:

All times are GMT -5. The time now is 05:23 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.