Shop Floor Talk  

Go Back   Shop Floor Talk > Members List

SFT Search:   

bunkclimber bunkclimber is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. allessence
    09-12-2019 03:28 PM
    It was crazy without the speed up. LOL.. I am to picky now to use the speedup tech.

    It was one of those things that why waste an opertunity to teach. it doesn't really make much sense to upset such a large section, unless of course you don't have any choice.

    People seeing this being able to happen I think is important.

    I did go out and buy some 1.250 sq stock so at some point will just use that for another mandrel and film that as well.

    with the right sized stock it cuts the time to less than half.

    Have you been forging much?
  2. allessence
    09-05-2019 07:43 PM
    In regards to?

    I am building a new shop. the thread is on SFT and on iforgeiron I don't believe

    No video on building a new shop, Though there are a bunch of other forging aspects.

    there is one video on putting up and down of the smoke stack on the trailer.

About Me

  • About bunkclimber
    electrican,welder,hydraulic mech
    xpermtl develpr
  • Signature
    Miller CP252TS MIG with S21E Feeder, Syncrowave 250 w/Weldcraft torches
    Lincoln TIG200 w/Weldcraft torches, LTEC 84i Plasma Cutter
    Gallemeyer Hydraulic Surface Grinder, Pratt Whitney 12x48 Engine Lathe
    Strands Gear Drive Drill Press, RongFu 3hp Gear Drive Drill
    Tannewitz 36" Contour Saw, 16" 5hp Chop Saw
    Rockwell 6x48 belt grinder,Grizzly 6x48 belt sander
    48" Chicago Box Pan Brake, Hydraulic compact Press Brake
    3 forklifts,4 generators,2 IR Air compressors
    Not Enough Room


Total Posts
Visitor Messages
General Information
  • Last Activity: 09-11-2019 05:12 AM
  • Join Date: 07-28-2006
  • Referrals: 0


Showing Friends 1 to 2 of 2
Web Search:

All times are GMT -5. The time now is 03:51 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.